Fin installation

A big thanks to team FCS who helped me install the fins.. and allign them straight just in the nick of time!!

not the angle i was after.. I using a 3 plug fcs set up for more freedom in the fin placement. Fins im using will be either, FCS MR twinnies or hand shaped 3 plug keels.


third plug yet to be installed.


the web of support tape.

Base Laminating

with the hot weather at easter i got a chance to do another laminating spree..

200ml was more than enough resin for one coat.

Top Deck Laminating

Finally i have got around to getting some resin.
I have used west system, but this stuff has a bit of an amber tint.. this good for a wood board.. but not so good for fiberglass.. which i intend to get into next..

this coat was done with 13oml of west resin this wasnt really enough as didnt give an even coating.

Leash plug

Installed a leash plug, just a simple model from you local surf store..

I always wonderd why leash plugs are in the middle a or to the left or right on fish shapes.. On personal experience, i tend to find the leash gets caught up around my leg if it is on the wrong side of the tail, but then if it is in the middle can rip the butt crack to shreds if you bail at the last moment.

Iv gone with a center plug, just cos i like it... for strength onyl time will tell if it holds the weight of the woodfish..

more sanding

phew so finished sanding the deck.. heres some profile shots:

top deck
base ( im going for a 3 plug fcs setup with custom fins or fcs.. depending on my budget)



i spent a good 10 hours of hand sanding till i decide to give in and go down to the local hardware store and purchase a $12 Rail master.. (this will surely come in handy for finishing the laminated decks)